CI-BDTLF-20 Bowie-Dick测试包

121℃，10分钟

或132-134℃，3.5分钟

紫色小盒

20个/盒，4盒/箱

CI-BDTLF121-20 Bowie-Dick测试包，121℃专用

121℃，11分钟

绿色小盒

20个/盒，4盒/箱

CI-BD110

Bowie-Dick测试卡 134℃，3.5分钟 100个/盒

CI-BD110：灭菌后蓝色变为黑色，变色不可逆

Procedures for Use

Test sterilizer once a day.

Test at the beginning of each day. A shortened cycle should be used to preheat the system (i.e. omit the drying phase). If the sterilizer is in continual use, then testing can be performed at any time, but it should be tested at the same time every day.

Place the pack on the bottom rack in the front section of the sterilizer, near the door and over the drain.

The test is most accurate when nothing else is in the chamber, so do not use this cycle to sterilize items or packs. Other items in this cycle may invalidate the test.

Run a pre-vacuum cycle following the parameters printed on the indicator instructions. You may eliminate the drying phase to save time without affecting the test.

After the cycle is complete, remove the pack and open to examine the indicator sheet. CAUTION! Test pack may still be hot so use caution when handling to avoid injury.

Record the necessary information on the sheet (or in a log book) and store for your records.

The filter paper pack can be discarded into a paper recycle bin.